/****************************************************************************** * * Copyright(c) 2007 - 2011 Realtek Corporation. All rights reserved. * * This program is free software; you can redistribute it and/or modify it * under the terms of version 2 of the GNU General Public License as * published by the Free Software Foundation. * * This program is distributed in the hope that it will be useful, but WITHOUT * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for * more details. * * You should have received a copy of the GNU General Public License along with * this program; if not, write to the Free Software Foundation, Inc., * 51 Franklin Street, Fifth Floor, Boston, MA 02110, USA * * ******************************************************************************/ /* ***** temporarily flag ******* */ #define CONFIG_SINGLE_IMG /* #define CONFIG_DISABLE_ODM */ /* for FPGA VERIFICATION config */ #define RTL8188E_FPGAtrue_PHY_VERIFICATION 0 /* ***** temporarily flag ******* */ /* * Public General Config */ #define AUTOCONF_INCLUDED #define RTL871X_MODULE_NAME "88EU" #define DRV_NAME "rtl8188eu" #define PLATFORM_LINUX /* #define CONFIG_IOCTL_CFG80211 */ #if defined(CONFIG_PLATFORM_ACTIONS_ATM702X) #ifndef CONFIG_IOCTL_CFG80211 #define CONFIG_IOCTL_CFG80211 #endif #endif #ifdef CONFIG_IOCTL_CFG80211 /* #define RTW_USE_CFG80211_STA_EVENT */ /* Indecate new sta asoc through cfg80211_new_sta */ #define CONFIG_CFG80211_FORCE_COMPATIBLE_2_6_37_UNDER /* #define CONFIG_DEBUG_CFG80211 */ /* #define CONFIG_DRV_ISSUE_PROV_REQ */ /* IOT FOR S2 */ #define CONFIG_SET_SCAN_DENY_TIMER /*#define SUPPLICANT_RTK_VERSION_LOWER_THAN_JB42*/ /* wpa_supplicant realtek version <= jb42 will be defined this */ #endif /* * Internal General Config */ /* #define CONFIG_H2CLBK */ #define CONFIG_EMBEDDED_FWIMG #ifdef CONFIG_EMBEDDED_FWIMG #define LOAD_FW_HEADER_FROM_DRIVER #endif /* #define CONFIG_FILE_FWIMG */ #define CONFIG_XMIT_ACK #ifdef CONFIG_XMIT_ACK #define CONFIG_ACTIVE_KEEP_ALIVE_CHECK #endif #define CONFIG_RECV_REORDERING_CTRL /* #define CONFIG_TCP_CSUM_OFFLOAD_RX */ /* #define CONFIG_DRVEXT_MODULE */ #define CONFIG_SUPPORT_USB_INT #ifdef CONFIG_SUPPORT_USB_INT /* #define CONFIG_USB_INTERRUPT_IN_PIPE */ #endif /* #ifndef CONFIG_MP_INCLUDED */ #define CONFIG_IPS #ifdef CONFIG_IPS /* #define CONFIG_IPS_LEVEL_2 */ /* enable this to set default IPS mode to IPS_LEVEL_2 */ #endif #define SUPPORT_HW_RFOFF_DETECTED #define CONFIG_LPS #if defined(CONFIG_LPS) && defined(CONFIG_SUPPORT_USB_INT) /* #define CONFIG_LPS_LCLK */ #endif #ifdef CONFIG_LPS_LCLK #define CONFIG_XMIT_THREAD_MODE #endif /*#define CONFIG_ANTENNA_DIVERSITY*/ /* #define CONFIG_CONCURRENT_MODE */ #ifdef CONFIG_CONCURRENT_MODE #define CONFIG_RUNTIME_PORT_SWITCH #define CONFIG_SCAN_BACKOP #define CONFIG_TSF_RESET_OFFLOAD /* For 2 PORT TSF SYNC. */ #endif #define CONFIG_IOL /* #else */ /* #ifndef CONFIG_MP_INCLUDED */ /* #endif */ /* #ifndef CONFIG_MP_INCLUDED */ #define CONFIG_AP_MODE #ifdef CONFIG_AP_MODE /* #define CONFIG_INTERRUPT_BASED_TXBCN */ /* Tx Beacon when driver BCN_OK ,BCN_ERR interrupt occurs */ #if defined(CONFIG_CONCURRENT_MODE) && defined(CONFIG_INTERRUPT_BASED_TXBCN) #undef CONFIG_INTERRUPT_BASED_TXBCN #endif #ifdef CONFIG_INTERRUPT_BASED_TXBCN /* #define CONFIG_INTERRUPT_BASED_TXBCN_EARLY_INT */ #define CONFIG_INTERRUPT_BASED_TXBCN_BCN_OK_ERR #endif #define CONFIG_NATIVEAP_MLME #ifndef CONFIG_NATIVEAP_MLME #define CONFIG_HOSTAPD_MLME #endif #define CONFIG_FIND_BEST_CHANNEL #endif #define CONFIG_P2P #ifdef CONFIG_P2P /* The CONFIG_WFD is for supporting the Wi-Fi display */ #define CONFIG_WFD #define CONFIG_P2P_REMOVE_GROUP_INFO /* #define CONFIG_DBG_P2P */ #define CONFIG_P2P_PS #define CONFIG_P2P_OP_CHK_SOCIAL_CH #define CONFIG_CFG80211_ONECHANNEL_UNDER_CONCURRENT /* replace CONFIG_P2P_CHK_INVITE_CH_LIST flag */ #define CONFIG_P2P_INVITE_IOT #endif /* Added by Kurt 20110511 */ #ifdef CONFIG_TDLS #define CONFIG_TDLS_DRIVER_SETUP /* #ifndef CONFIG_WFD */ /* #define CONFIG_WFD */ /* #endif */ /* #define CONFIG_TDLS_AUTOSETUP */ #define CONFIG_TDLS_AUTOCHECKALIVE /* #define CONFIG_TDLS_CH_SW */ /* Enable this flag only when we confirm that TDLS CH SW is supported in FW */ #endif #define CONFIG_SKB_COPY /* for amsdu */ /* #define CONFIG_LED */ #ifdef CONFIG_LED #define CONFIG_SW_LED #ifdef CONFIG_SW_LED /* #define CONFIG_LED_HANDLED_BY_CMD_THREAD */ #endif #endif /* CONFIG_LED */ #ifdef CONFIG_IOL #define CONFIG_IOL_NEW_GENERATION #define CONFIG_IOL_READ_EFUSE_MAP /* #define DBG_IOL_READ_EFUSE_MAP */ /* #define CONFIG_IOL_LLT */ #define CONFIG_IOL_EFUSE_PATCH /* #define CONFIG_IOL_IOREG_CFG */ /* #define CONFIG_IOL_IOREG_CFG_DBG */ #endif #define CONFIG_GLOBAL_UI_PID #define CONFIG_LAYER2_ROAMING #define CONFIG_LAYER2_ROAMING_RESUME /* #define CONFIG_ADAPTOR_INFO_CACHING_FILE */ /* now just applied on 8192cu only, should make it general... */ /* #define CONFIG_RESUME_IN_WORKQUEUE */ /* #define CONFIG_SET_SCAN_DENY_TIMER */ #define CONFIG_LONG_DELAY_ISSUE #define CONFIG_NEW_SIGNAL_STAT_PROCESS /* #define CONFIG_SIGNAL_DISPLAY_DBM */ /* display RX signal with dbm */ #ifdef CONFIG_SIGNAL_DISPLAY_DBM /* #define CONFIG_BACKGROUND_NOISE_MONITOR */ #endif #define RTW_NOTCH_FILTER 0 /* 0:Disable, 1:Enable, */ #define CONFIG_TX_MCAST2UNI /* Support IP multicast->unicast */ /* #define CONFIG_CHECK_AC_LIFETIME */ /* Check packet lifetime of 4 ACs. */ /* * Interface Related Config */ #ifndef CONFIG_MINIMAL_MEMORY_USAGE #define CONFIG_USB_TX_AGGREGATION #define CONFIG_USB_RX_AGGREGATION #endif /* #define CONFIG_REDUCE_USB_TX_INT */ /* Trade-off: Improve performance, but may cause TX URBs blocked by USB Host/Bus driver on few platforms. */ /* #define CONFIG_EASY_REPLACEMENT */ /* * CONFIG_USE_USB_BUFFER_ALLOC_XX uses Linux USB Buffer alloc API and is for Linux platform only now! */ /* #define CONFIG_USE_USB_BUFFER_ALLOC_TX */ /* Trade-off: For TX path, improve stability on some platforms, but may cause performance degrade on other platforms. */ /* #define CONFIG_USE_USB_BUFFER_ALLOC_RX */ /* For RX path */ #ifdef CONFIG_USE_USB_BUFFER_ALLOC_RX #else #define CONFIG_PREALLOC_RECV_SKB #ifdef CONFIG_PREALLOC_RECV_SKB #define CONFIG_FIX_NR_BULKIN_BUFFER /* only use PREALLOC_RECV_SKB buffer, don't alloc skb at runtime */ #endif #endif /* * USB VENDOR REQ BUFFER ALLOCATION METHOD * if not set we'll use function local variable (stack memory) */ /* #define CONFIG_USB_VENDOR_REQ_BUFFER_DYNAMIC_ALLOCATE */ #define CONFIG_USB_VENDOR_REQ_BUFFER_PREALLOC #define CONFIG_USB_VENDOR_REQ_MUTEX #define CONFIG_VENDOR_REQ_RETRY /* #define CONFIG_USB_SUPPORT_ASYNC_VDN_REQ */ /* * HAL Related Config */ #define RTL8188E_RX_PACKET_INCLUDE_CRC 0 #define SUPPORTED_BLOCK_IO /* #define CONFIG_ONLY_ONE_OUT_EP_TO_LOW 0 */ #define CONFIG_OUT_EP_WIFI_MODE 0 #define ENABLE_USB_DROP_INCORRECT_OUT #define DISABLE_BB_RF 0 /* #define RTL8191C_FPGA_NETWORKTYPE_ADHOC 0 */ #ifdef CONFIG_MP_INCLUDED #define MP_DRIVER 1 #define CONFIG_MP_IWPRIV_SUPPORT /* #undef CONFIG_USB_TX_AGGREGATION */ /* #undef CONFIG_USB_RX_AGGREGATION */ #else #define MP_DRIVER 0 #endif /* * Platform Related Config */ #ifdef CONFIG_PLATFORM_MN10300 #define CONFIG_SPECIAL_SETTING_FOR_FUNAI_TV #define CONFIG_USE_USB_BUFFER_ALLOC_RX #if defined(CONFIG_POWER_SAVING) #undef CONFIG_POWER_SAVING #endif #endif/* CONFIG_PLATFORM_MN10300 */ #if defined(CONFIG_PLATFORM_ACTIONS_ATM702X) #ifdef CONFIG_USB_TX_AGGREGATION #undef CONFIG_USB_TX_AGGREGATION #endif #ifndef CONFIG_USE_USB_BUFFER_ALLOC_TX #define CONFIG_USE_USB_BUFFER_ALLOC_TX #endif #ifndef CONFIG_USE_USB_BUFFER_ALLOC_RX #define CONFIG_USE_USB_BUFFER_ALLOC_RX #endif #endif #ifdef CONFIG_USB_TX_AGGREGATION /* #define CONFIG_TX_EARLY_MODE */ #endif #ifdef CONFIG_TX_EARLY_MODE #define RTL8188E_EARLY_MODE_PKT_NUM_10 0 #endif /*#define CONFIG_RF_POWER_TRIM */ #define CONFIG_80211D #ifdef CONFIG_GPIO_WAKEUP #ifndef WAKEUP_GPIO_IDX #define WAKEUP_GPIO_IDX 7 #endif #endif #define CONFIG_ATTEMPT_TO_FIX_AP_BEACON_ERROR /* * Debug Related Config */ #define DBG 1 #define CONFIG_PROC_DEBUG #define DBG_CONFIG_ERROR_DETECT /* #define DBG_CONFIG_ERROR_DETECT_INT */ #define DBG_CONFIG_ERROR_RESET /* #define DBG_IO */ /* #define DBG_DELAY_OS */ /* #define DBG_MEM_ALLOC */ /* #define DBG_IOCTL */ /* #define DBG_TX */ /* #define DBG_XMIT_BUF */ /* #define DBG_XMIT_BUF_EXT */ /* #define DBG_TX_DROP_FRAME */ /* #define DBG_RX_DROP_FRAME */ /* #define DBG_RX_SEQ */ /* #define DBG_RX_SIGNAL_DISPLAY_PROCESSING */ /* #define DBG_RX_SIGNAL_DISPLAY_SSID_MONITORED "jeff-ap" */ /* #define DBG_SHOW_MCUFWDL_BEFORE_51_ENABLE */ /* #define DBG_ROAMING_TEST */ /* #define DBG_HAL_INIT_PROFILING */ /* TX use 1 urb */ /* #define CONFIG_SINGLE_XMIT_BUF */ /* RX use 1 urb */ /* #define CONFIG_SINGLE_RECV_BUF */ #define DBG_RX_DFRAME_RAW_DATA