skyfall/rtl8188eu
1
0
Fork 0
mirror of https://github.com/lwfinger/rtl8188eu.git synced 2024-11-14 17:09:36 +00:00
Code Issues Projects Releases Packages Wiki Activity Actions
rtl8188eu/autoconf.h
Larry Finger 9d070c63c5 rtl8188eu: Remove CONFIG_IOCTL_CFG80211 from autoconf.h 
This configuration option is now set in Makefile.

Signed-off-by: Larry Finger <Larry.Finger@lwfinger.net>
_
2022-01-26 13:10:04 -06:00

338 lines
8.1 KiB
C
Raw Blame History

/* SPDX-License-Identifier: GPL-2.0 */
/* Copyright(c) 2007 - 2016 Realtek Corporation. All rights reserved. */
/* ***** temporarily flag ******* */
#define CONFIG_SINGLE_IMG
/* #define CONFIG_DISABLE_ODM */
/* for FPGA VERIFICATION config */
#define RTL8188E_FPGAtrue_PHY_VERIFICATION 0
/* ***** temporarily flag ******* */
/*
* Public General Config
*/
#define AUTOCONF_INCLUDED
#define RTL871X_MODULE_NAME "88EU"
#define DRV_NAME "rtl8188eu"
#define PLATFORM_LINUX
#if defined(CONFIG_PLATFORM_ACTIONS_ATM702X)
#ifndef CONFIG_IOCTL_CFG80211
#define CONFIG_IOCTL_CFG80211
#endif
#endif
#ifdef CONFIG_IOCTL_CFG80211
/* #define RTW_USE_CFG80211_STA_EVENT */ /* Indecate new sta asoc through cfg80211_new_sta */
#define CONFIG_CFG80211_FORCE_COMPATIBLE_2_6_37_UNDER
/* #define CONFIG_DEBUG_CFG80211 */
/* #define CONFIG_DRV_ISSUE_PROV_REQ */ /* IOT FOR S2 */
#define CONFIG_SET_SCAN_DENY_TIMER
/*#define SUPPLICANT_RTK_VERSION_LOWER_THAN_JB42*/ /* wpa_supplicant realtek version <= jb42 will be defined this */
#endif
/*
* Internal General Config
*/
/* #define CONFIG_H2CLBK */
#define CONFIG_EMBEDDED_FWIMG
#ifdef CONFIG_EMBEDDED_FWIMG
#define LOAD_FW_HEADER_FROM_DRIVER
#endif
/* #define CONFIG_FILE_FWIMG */
#define CONFIG_XMIT_ACK
#ifdef CONFIG_XMIT_ACK
#define CONFIG_ACTIVE_KEEP_ALIVE_CHECK
#endif
#define CONFIG_RECV_REORDERING_CTRL
/* #define CONFIG_TCP_CSUM_OFFLOAD_RX */
/* #define CONFIG_DRVEXT_MODULE */
#define CONFIG_SUPPORT_USB_INT
#ifdef CONFIG_SUPPORT_USB_INT
/* #define CONFIG_USB_INTERRUPT_IN_PIPE */
#endif
/* #ifndef CONFIG_MP_INCLUDED */
#define CONFIG_IPS
#ifdef CONFIG_IPS
/* #define CONFIG_IPS_LEVEL_2 */ /* enable this to set default IPS mode to IPS_LEVEL_2 */
#endif
#define SUPPORT_HW_RFOFF_DETECTED
#define CONFIG_LPS
#if defined(CONFIG_LPS) && defined(CONFIG_SUPPORT_USB_INT)
/* #define CONFIG_LPS_LCLK */
#endif
#ifdef CONFIG_LPS_LCLK
#define CONFIG_XMIT_THREAD_MODE
#endif
/*#define CONFIG_ANTENNA_DIVERSITY*/
/* #define CONFIG_CONCURRENT_MODE */
#ifdef CONFIG_CONCURRENT_MODE
#define CONFIG_RUNTIME_PORT_SWITCH
#define CONFIG_SCAN_BACKOP
#define CONFIG_TSF_RESET_OFFLOAD /* For 2 PORT TSF SYNC. */
#endif
#define CONFIG_IOL
/* #else */ /* #ifndef CONFIG_MP_INCLUDED */
/* #endif */ /* #ifndef CONFIG_MP_INCLUDED */
#define CONFIG_AP_MODE
#ifdef CONFIG_AP_MODE
/* #define CONFIG_INTERRUPT_BASED_TXBCN */ /* Tx Beacon when driver BCN_OK ,BCN_ERR interrupt occurs */
#if defined(CONFIG_CONCURRENT_MODE) && defined(CONFIG_INTERRUPT_BASED_TXBCN)
#undef CONFIG_INTERRUPT_BASED_TXBCN
#endif
#ifdef CONFIG_INTERRUPT_BASED_TXBCN
/* #define CONFIG_INTERRUPT_BASED_TXBCN_EARLY_INT */
#define CONFIG_INTERRUPT_BASED_TXBCN_BCN_OK_ERR
#endif
#define CONFIG_NATIVEAP_MLME
#ifndef CONFIG_NATIVEAP_MLME
#define CONFIG_HOSTAPD_MLME
#endif
#define CONFIG_FIND_BEST_CHANNEL
#endif
#define CONFIG_P2P
#ifdef CONFIG_P2P
/* The CONFIG_WFD is for supporting the Wi-Fi display */
#define CONFIG_WFD
#define CONFIG_P2P_REMOVE_GROUP_INFO
/* #define CONFIG_DBG_P2P */
#define CONFIG_P2P_PS
#define CONFIG_P2P_OP_CHK_SOCIAL_CH
#define CONFIG_CFG80211_ONECHANNEL_UNDER_CONCURRENT /* replace CONFIG_P2P_CHK_INVITE_CH_LIST flag */
#define CONFIG_P2P_INVITE_IOT
#endif
/* Added by Kurt 20110511 */
#ifdef CONFIG_TDLS
#define CONFIG_TDLS_DRIVER_SETUP
/* #ifndef CONFIG_WFD */
/* #define CONFIG_WFD */
/* #endif */
/* #define CONFIG_TDLS_AUTOSETUP */
#define CONFIG_TDLS_AUTOCHECKALIVE
/* #define CONFIG_TDLS_CH_SW */ /* Enable this flag only when we confirm that TDLS CH SW is supported in FW */
#endif
#define CONFIG_SKB_COPY /* for amsdu */
/* #define CONFIG_LED */
#ifdef CONFIG_LED
#define CONFIG_SW_LED
#ifdef CONFIG_SW_LED
/* #define CONFIG_LED_HANDLED_BY_CMD_THREAD */
#endif
#endif /* CONFIG_LED */
#ifdef CONFIG_IOL
#define CONFIG_IOL_NEW_GENERATION
#define CONFIG_IOL_READ_EFUSE_MAP
/* #define DBG_IOL_READ_EFUSE_MAP */
/* #define CONFIG_IOL_LLT */
#define CONFIG_IOL_EFUSE_PATCH
/* #define CONFIG_IOL_IOREG_CFG */
/* #define CONFIG_IOL_IOREG_CFG_DBG */
#endif
#define CONFIG_GLOBAL_UI_PID
#define CONFIG_LAYER2_ROAMING
#define CONFIG_LAYER2_ROAMING_RESUME
/* #define CONFIG_ADAPTOR_INFO_CACHING_FILE */ /* now just applied on 8192cu only, should make it general... */
/* #define CONFIG_RESUME_IN_WORKQUEUE */
/* #define CONFIG_SET_SCAN_DENY_TIMER */
#define CONFIG_LONG_DELAY_ISSUE
#define CONFIG_NEW_SIGNAL_STAT_PROCESS
/* #define CONFIG_SIGNAL_DISPLAY_DBM */ /* display RX signal with dbm */
#ifdef CONFIG_SIGNAL_DISPLAY_DBM
/* #define CONFIG_BACKGROUND_NOISE_MONITOR */
#endif
#define RTW_NOTCH_FILTER 0 /* 0:Disable, 1:Enable, */
#define CONFIG_TX_MCAST2UNI /* Support IP multicast->unicast */
/* #define CONFIG_CHECK_AC_LIFETIME */ /* Check packet lifetime of 4 ACs. */
/*
* Interface Related Config
*/
#ifndef CONFIG_MINIMAL_MEMORY_USAGE
#define CONFIG_USB_TX_AGGREGATION
#define CONFIG_USB_RX_AGGREGATION
#endif
/* #define CONFIG_REDUCE_USB_TX_INT */ /* Trade-off: Improve performance, but may cause TX URBs blocked by USB Host/Bus driver on few platforms. */
/* #define CONFIG_EASY_REPLACEMENT */
/*
* CONFIG_USE_USB_BUFFER_ALLOC_XX uses Linux USB Buffer alloc API and is for Linux platform only now!
*/
/* #define CONFIG_USE_USB_BUFFER_ALLOC_TX */ /* Trade-off: For TX path, improve stability on some platforms, but may cause performance degrade on other platforms. */
/* #define CONFIG_USE_USB_BUFFER_ALLOC_RX */ /* For RX path */
#ifdef CONFIG_USE_USB_BUFFER_ALLOC_RX
#else
#define CONFIG_PREALLOC_RECV_SKB
#ifdef CONFIG_PREALLOC_RECV_SKB
#define CONFIG_FIX_NR_BULKIN_BUFFER /* only use PREALLOC_RECV_SKB buffer, don't alloc skb at runtime */
#endif
#endif
/*
* USB VENDOR REQ BUFFER ALLOCATION METHOD
* if not set we'll use function local variable (stack memory)
*/
/* #define CONFIG_USB_VENDOR_REQ_BUFFER_DYNAMIC_ALLOCATE */
#define CONFIG_USB_VENDOR_REQ_BUFFER_PREALLOC
#define CONFIG_USB_VENDOR_REQ_MUTEX
#define CONFIG_VENDOR_REQ_RETRY
/* #define CONFIG_USB_SUPPORT_ASYNC_VDN_REQ */
/*
* HAL Related Config
*/
#define RTL8188E_RX_PACKET_INCLUDE_CRC 0
#define SUPPORTED_BLOCK_IO
/* #define CONFIG_ONLY_ONE_OUT_EP_TO_LOW 0 */
#define CONFIG_OUT_EP_WIFI_MODE 0
#define ENABLE_USB_DROP_INCORRECT_OUT
#define DISABLE_BB_RF 0
/* #define RTL8191C_FPGA_NETWORKTYPE_ADHOC 0 */
#ifdef CONFIG_MP_INCLUDED
#define MP_DRIVER 1
#define CONFIG_MP_IWPRIV_SUPPORT
/* #undef CONFIG_USB_TX_AGGREGATION */
/* #undef CONFIG_USB_RX_AGGREGATION */
#else
#define MP_DRIVER 0
#endif
/*
* Platform Related Config
*/
#ifdef CONFIG_PLATFORM_MN10300
#define CONFIG_SPECIAL_SETTING_FOR_FUNAI_TV
#define CONFIG_USE_USB_BUFFER_ALLOC_RX
#if defined(CONFIG_POWER_SAVING)
#undef CONFIG_POWER_SAVING
#endif
#endif/* CONFIG_PLATFORM_MN10300 */
#if defined(CONFIG_PLATFORM_ACTIONS_ATM702X)
#ifdef CONFIG_USB_TX_AGGREGATION
#undef CONFIG_USB_TX_AGGREGATION
#endif
#ifndef CONFIG_USE_USB_BUFFER_ALLOC_TX
#define CONFIG_USE_USB_BUFFER_ALLOC_TX
#endif
#ifndef CONFIG_USE_USB_BUFFER_ALLOC_RX
#define CONFIG_USE_USB_BUFFER_ALLOC_RX
#endif
#endif
#ifdef CONFIG_USB_TX_AGGREGATION
/* #define CONFIG_TX_EARLY_MODE */
#endif
#ifdef CONFIG_TX_EARLY_MODE
#define RTL8188E_EARLY_MODE_PKT_NUM_10 0
#endif
/*#define CONFIG_RF_POWER_TRIM */
#define CONFIG_80211D
#ifdef CONFIG_GPIO_WAKEUP
#ifndef WAKEUP_GPIO_IDX
#define WAKEUP_GPIO_IDX 7
#endif
#endif
#define CONFIG_ATTEMPT_TO_FIX_AP_BEACON_ERROR
/*
* Debug Related Config
*/
#define DBG 1
#define CONFIG_PROC_DEBUG
#define DBG_CONFIG_ERROR_DETECT
/* #define DBG_CONFIG_ERROR_DETECT_INT */
#define DBG_CONFIG_ERROR_RESET
/* #define DBG_IO */
/* #define DBG_DELAY_OS */
/* #define DBG_MEM_ALLOC */
/* #define DBG_IOCTL */
/* #define DBG_TX */
/* #define DBG_XMIT_BUF */
/* #define DBG_XMIT_BUF_EXT */
/* #define DBG_TX_DROP_FRAME */
/* #define DBG_RX_DROP_FRAME */
/* #define DBG_RX_SEQ */
/* #define DBG_RX_SIGNAL_DISPLAY_PROCESSING */
/* #define DBG_RX_SIGNAL_DISPLAY_SSID_MONITORED "jeff-ap" */
/* #define DBG_SHOW_MCUFWDL_BEFORE_51_ENABLE */
/* #define DBG_ROAMING_TEST */
/* #define DBG_HAL_INIT_PROFILING */
/* TX use 1 urb */
/* #define CONFIG_SINGLE_XMIT_BUF */
/* RX use 1 urb */
/* #define CONFIG_SINGLE_RECV_BUF */
#define DBG_RX_DFRAME_RAW_DATA
Reference in a new issue View git blame Copy permalink